![]() ![]() ![]() Cleaning the vent means going up on the roof and clearing the clog from there - a hose at full blast will usually do this.Īs for fully removing the overflow and parts. You need air behind water for it to drain quickly otherwise it's like water draining from an upside-down bottle. The overflow tube is a safety feature that channels water that has overfilled the tub back down into the drain pipes before it can spill over the edge of the tub. If that doesn't happen and the drainage does not improve, then you may have a clogged vent. Estimated Cost: 3 to 10 Problems with a leaky bathtub are often traced to the overflow tube or overflow drain assembly. The plunger should pull some amount of gunk back up into the tub while you're using it, even through the grate. Should that fail, use draino or physically pry off the grate for an auger. With the tub 1/2 full of water and holding the wet cloth over the overflow vent, a plunger should then be able to clear the clog because it will force water down the drain (horizontal or vertical) rather than pushing water up the overflow pipe (or pulling air down it). What works for me is to use a wet cloth to seal off the overflow (replace it first to make as small an opening as possible). If that drains fast, then the clog is in the horizontal arm and no clearing through the overflow will help you. While the tub is draining slowly, pour water down the overflow through a funnel. Oh well, problem solved, I guess! I don't take baths so am not concerned about not being able to close it.įirst, make sure that the clog is accessible via the overflow. However, somehow in my jiggling I must've loosened the clog, since the tub is now draining well. I assume that the stopper is suspended in the overflow pipe, like Tester101's second image.ĮDIT 2: After fiddling with the lever more I was still unable to get the stopper out. The drain fixture is just a grate (can't get a snake through). Is there some trick to this? Should I just pull hard? Or does it require disassembly from behind the wall?ĮDIT: Sorry for not being more specific about the fixture: the tub does not have a pop-up stopper in the tub floor. I've tried a moderate amount of force, but I don't want to break anything and be in a worse spot. It seems stuck-there's maybe 1/2" of vertical travel and I can't pull it up any more. I was planning on going through the overflow / drain stopper toggle plate:īut I can't remove the stopper and link from the overflow pipe. The drain in our tub is slow and I'd like to snake it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |